When making a 3D alginate mold of your penis, proper water temperature is crucial. A few degrees off can mean the difference between a perfect mold and a failed attempt. This is especially true when molding an erect penis. 

You may not realize it, but erections can be quickly lost. Without stimulus, the average man has approximately 2 minutes before he begins to lose his erection. The Clone-A-Willy Kit is designed with this in mind. Our specially formulated, body safe alginate allows enough time to mix it with water, pour it into your molding tube, and insert your penis, without needing to hold so long that you'll lose your erection. The Clone-A-Willy penis casting kit requires holding an erection for just 60 seconds.   No problem! 

Proper water temperature is the key. Use the thermometer included in each kit to reach correct water temperature and follow the directions from there. Specific, body temperature water will give consistent results every time. Using warmer water will make the mixture gel faster – using cooler water will make it gel more slowly.

With Clone-A-Willy's specially formulated 3D alginate molding gel, creating a perfect mold of your manhood is a breeze!